MT-01 > MT-01
Install Barnett spring set
KoosMT01:
Hi all,
Iam going to install a Barnett spring set.
I read somewhere on the internet that if i put my MT01 on the sidestand, i can remove de clutch cover without losing the oil.
My bike has a 195/55 tire, so it's already i little more tilted then standard.
Can anyone here confirm this? Other tips and trick are also welcome before i start, thanks in advance!
[ Guests cannot view attachments ]
KoosMT01:
Oops looking at the photo above, i see now that the bike is tilted to the wrong side ::)
Maybe i coold put the bike in first gear and lean it to a wall
TimR:
You can just lean it on something and the oil will not really want to run out too bad...! Its possible. I did like this the first couple of times...
I recently changed all the clutch friction plates in my Barnett kit, and drained the engine oil rather than faff about....No need to drain the oil tank. Then just refill.
Depends how lazy you are !
Danmt:
I re-used the original spring plate, the Barnett one seemed very flimsy and there was no real need to replace it.
KoosMT01:
--- Quote from: TimR on July 29, 2021, 06:49:15 pm ---You can just lean it on something and the oil will not really want to run out too bad...! Its possible. I did like this the first couple of times...
I recently changed all the clutch friction plates in my Barnett kit, and drained the engine oil rather than faff about....No need to drain the oil tank. Then just refill.
Depends how lazy you are !
--- End quote ---
I'll try this, iam as lazy as possible as long it doesnt affect the result!
Navigation
[0] Message Index
[#] Next page
Go to full version